Fluroxene
-
Fluroxene
structure -
-
CAS No:
406-90-6
-
Formula:
C4H5F3O
-
Chemical Name:
Fluroxene
-
Synonyms:
Ethene,(2,2,2-trifluoroethoxy)-;Ether,2,2,2-trifluoroethyl vinyl;(2,2,2-Trifluoroethoxy)ethene;Fluoromar;Fluoroxene;Fluroxene;2,2,2-Trifluoroethyl vinyl ether;Trifluoroethyl vinyl ether;2-Ethenoxy-1,1,1-trifluoroethane
- Categories:
-
CAS No:
Description
Fluroxene is a volatile, inhalational anesthetic, and was the first halogenated hydrocarbon anesthetic to be introduced.
Volatile Liquid. Bp: 43°C. Density: 1.14 g cm-3 . Formerly used as an inhalation anesthetic.|Liquid. [inhalation anesthetic] [Note: A gas above 109°F.]
Volatile Liquid. Bp: 43°C. Density: 1.14 g cm-3 . Formerly used as an inhalation anesthetic.|Fluroxene is an organofluorine compound.
Fluroxene Basic Attributes
126.07700
126.08
206-977-1
FO7JHA3G03
760364
1993
DTXSID5059957
2909199090
Characteristics
9.23000
1.70880
Volatile Liquid. Bp: 43°C. Density: 1.14 g cm-3 . Formerly used as an inhalation anesthetic.
1.135 g/cm3 @ Temp: 20 °C
42.5 °C
-30°C
1.3192
4mg/L(temperature not stated)
286 mmHg
mmo-sat 3 pph/2H MUREAV 58,183,78
Combustible Liquid [potentially EXPLOSIVE!]
No rapid reaction with air No rapid reaction with water
Ethers
FLUOROXENE is non-flammable but combustible. Can form explosive mixtures with air. Reacts with strong oxidizing agents.
Combustible Liquid [potentially EXPLOSIVE!]
Safety Information
II
3
1993
R11
S16-S36-S39-S26
KO4250000
F: Flammable;Xi: Irritant;
P201, P202, P210, P233, P240, P241, P242, P243, P280, P281, P303+P361+P353, P305+P351+P338, P308+P313, P310, P370+P378, P403+P235, P405, P501
H225
Excerpt from ERG Guide 128 [Flammable Liquids (Water-Immiscible)]: HIGHLY FLAMMABLE: Will be easily ignited by heat, sparks or flames. Vapors may form explosive mixtures with air. Vapors may travel to source of ignition and flash back. Most vapors are heavier than air. They will spread along ground and collect in low or confined areas (sewers, basements, tanks). Vapor explosion hazard indoors, outdoors or in sewers. Those substances designated with a (P) may polymerize explosively when heated or involved in a fire. Runoff to sewer may create fire or explosion hazard. Containers may explode when heated. Many liquids are lighter than water. Substance may be transported hot. For hybrid vehicles, ERG Guide 147 (lithium ion batteries) or ERG Guide 138 (sodium batteries) should also be consulted. If molten aluminum is involved, refer to ERG Guide 169. (ERG, 2016)
Excerpt from ERG Guide 128 [Flammable Liquids (Water-Immiscible)]: CAUTION: All these products have a very low flash point: Use of water spray when fighting fire may be inefficient. CAUTION: For mixtures containing alcohol or polar solvent, alcohol-resistant foam may be more effective. SMALL FIRE: Dry chemical, CO2, water spray or regular foam. LARGE FIRE: Water spray, fog or regular foam. Do not use straight streams. Move containers from fire area if you can do it without risk. FIRE INVOLVING TANKS OR CAR/TRAILER LOADS: Fight fire from maximum distance or use unmanned hose holders or monitor nozzles. Cool containers with flooding quantities of water until well after fire is out. Withdraw immediately in case of rising sound from venting safety devices or discoloration of tank. ALWAYS stay away from tanks engulfed in fire. For massive fire, use unmanned hose holders or monitor nozzles; if this is impossible, withdraw from area and let fire burn. (ERG, 2016)
Excerpt from ERG Guide 128 [Flammable Liquids (Water-Immiscible)]: As an immediate precautionary measure, isolate spill or leak area for at least 50 meters (150 feet) in all directions. LARGE SPILL: Consider initial downwind evacuation for at least 300 meters (1000 feet). FIRE: If tank, rail car or tank truck is involved in a fire, ISOLATE for 800 meters (1/2 mile) in all directions; also, consider initial evacuation for 800 meters (1/2 mile) in all directions. (ERG, 2016)
Excerpt from ERG Guide 128 [Flammable Liquids (Water-Immiscible)]: ELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area). All equipment used when handling the product must be grounded. Do not touch or walk through spilled material. Stop leak if you can do it without risk. Prevent entry into waterways, sewers, basements or confined areas. A vapor-suppressing foam may be used to reduce vapors. Absorb or cover with dry earth, sand or other non-combustible material and transfer to containers. Use clean, non-sparking tools to collect absorbed material. LARGE SPILL: Dike far ahead of liquid spill for later disposal. Water spray may reduce vapor, but may not prevent ignition in closed spaces. (ERG, 2016)
Skin: No recommendation is made specifying the need for personal protective equipment for the body. Eyes: Wear appropriate eye protection to prevent eye contact. Wash skin: No recommendation is made specifying the need for washing the substance from the skin (either immediately or at the end of the work shift). Remove: No recommendation is made specifying the need for removing clothing that becomes wet or contaminated. Change: No recommendation is made specifying the need for the worker to change clothing after the work shift. (NIOSH, 2016)|(See protection codes)
Drug Information
Exposure Routes: inhalation, ingestion, skin and/or eye contact Symptoms: Irritation eyes; central nervous system depression, analgesia, anesthesia, convulsions, respiratory depression Target Organs: Eyes, central nervous system (NIOSH, 2016)
Eye: If this chemical contacts the eyes, immediately wash the eyes with large amounts of water, occasionally lifting the lower and upper lids. Get medical attention immediately. Contact lenses should not be worn when working with this chemical. Skin: If this chemical contacts the skin, wash the contaminated skin with soap and water. Breathing: If a person breathes large amounts of this chemical, move the exposed person to fresh air at once. If breathing has stopped, perform mouth-to-mouth resuscitation. Keep the affected person warm and at rest. Get medical attention as soon as possible. Swallow: If this chemical has been swallowed, get medical attention immediately. (NIOSH, 2016)|(See procedures)
fluroxene
inhalation, ingestion, skin and/or eye contact
irritation eyes; central nervous system depression, analgesia, anesthesia, convulsions, resp depression
Eyes, central nervous system
Fluroxene Use and Manufacturing
Ca channel blocker, coronary vasodilator
Ethene, (2,2,2-trifluoroethoxy)-: ACTIVE
Computed Properties
Molecular Weight:126.08
XLogP3:1.9
Hydrogen Bond Acceptor Count:4
Rotatable Bond Count:2
Exact Mass:126.02924926
Monoisotopic Mass:126.02924926
Topological Polar Surface Area:9.2
Heavy Atom Count:8
Complexity:75.8
Covalently-Bonded Unit Count:1
Compound Is Canonicalized:Yes
Learn More Other Chemicals
-
Cefalexin lysine salt
53950-14-4
-
3,4-BIS(METHOXYCARBONYL)PHENYLBORONIC ACID
1072951-51-9
-
4-Hydroxy-2(5H)-furanone
541-57-1
-
ethyl 2-amino-3-nitro-benzoate Formula
61063-11-4
-
(T-4)-Bis(N-ethyl-N-phenylcarbamodithioato-κS,κS′)zinc Formula
14634-93-6
-
Dihexyl disulfide Formula
10496-15-8
-
2,2-Dimethylglutaric anhydride Structure
2938-48-9
-
Isopentene / Isoamylene Structure
78-79-5
-
What is Dimethyl sulfoxide
67-68-5
-
What is 1,1′-Dibutyl 2,2′-thiobis[acetate]
4121-12-4