Home > Community > About solid feeding
Upvote

VOTE

Downvote
+ Chemistry
Posted by
Kenneth Armstrong

About solid feeding

Donald Emily  Follow
Your problem conditions are not specific.If the feeding is allowed, you can use the plug.Make a 60-80 destination powder, you can consult the alkaline producer. More
Upvote

VOTE

Downvote
Billy Baldwin  Follow
The automatic feeder transported by the dual screw should be feeding, thank you More
Upvote

VOTE

Downvote
Dave Shawtie  Follow
The alkali -fixed feed can be considered using the automatic feeder transported by screw transportation. It is best to use double screw. Double screw feeding is more uniform, accurate, and good for self -cleaning.Fed the accurate.The screw can be disassembled quickly, and the fighting is easy to clean. If it is required to be higher, you can configure the solid ingredient scale. You can adjust it by the screw speed. The feeding amount can be adjusted arbitrarily within a certain range. More
Upvote

VOTE

Downvote
Arthur Renner  Follow
It is better to use liquid alkali, convenient measurement, and convenient feed.
With 32%liquid alkali, it does not need to be insulated in winter without less than 0 degrees.
Use solid alkali and buy powder directly to prevent alkali dust. More
Upvote

VOTE

Downvote
Bruce A McIntyre  Follow
The liquid alkali cannot be used, and the water is too much.
Is there a powder -like solid alkali? More
Upvote

VOTE

Downvote
Armando Viray  Follow
The reactive kettle is closed and automatic feeding equipment, the pipeline of the transportation material is connected to the workshop floor, and the electrical electrostatic of the material is taken away.Anti -blowing, increasing inert gas in the kettle and preventing accidents.The reactor closed automatic feeding equipment replaces the powder and solid granules in the reaction kettle. The equipment is connected to the dense and soft connection of the reactor. The dust and dust are not produced during the feeding.At this time, the organic solvents in the kettle are eliminated, the time is fast and efficient, and the labor intensity of employees is reduced.The device is controlled by PLC. According to the actual production needs of the customer, the DCS control system can be connected to the workshop control system.It has been put into use in the production of pesticide ingredients, and it has been put into use in the reactor instead of artificially invested dysizide and ultra -fine potassium carbonate. More
Upvote

VOTE

Downvote
Andi Quercia  Follow
Agree with the fifth floor.In addition, you can open a hole of DN80 on the reaction kettle (the best for spare). If you connect the ball valve, you don't need to open the holes.Metropolitan problems, you can use the filter to filter first, and then add it. More
Upvote

VOTE

Downvote