Product
Supplier
Encyclopedia
Inquiry
Home > Encyclopedia > 2-Pyridinecarboxylic acid, 2-acetylhydrazide

2-Pyridinecarboxylic acid, 2-acetylhydrazide

2-Pyridinecarboxylic acid, 2-acetylhydrazide structure

2-Pyridinecarboxylic acid, 2-acetylhydrazide 

structure
  • CAS No:

    17433-31-7

  • Formula:

    C8H9N3O2

  • Chemical Name:

    2-Pyridinecarboxylic acid, 2-acetylhydrazide

  • Synonyms:

    2-Pyridinecarboxylic acid,2-acetylhydrazide;Hydrazine,1-acetyl-2-picolinoyl-;NSC 68626;1-Acetyl-2-picolinoylhydrazine;Azapicyl

Description

Colorless powder.


1-acetyl-2-picolinoylhydrazine is a colorless powder. (NTP, 1992)


1-acetyl-2-picolinoylhydrazine is a colorless powder. (NTP, 1992)|Azapicyl is a hydrazine compound that has been investigated for antineoplastic activity. (NCI04)

2-Pyridinecarboxylic acid, 2-acetylhydrazide Basic Attributes

181.19184

179.18

186TH42ZNH

68626

2811

DTXSID2024408

C1007

Characteristics

71.1

-0.6

1-acetyl-2-picolinoylhydrazine is a colorless powder. (NTP, 1992)

1.2444 (rough estimate)

175-177.5 °C @ Solvent: Methanol, Ethyl acetate

314.3°C (rough estimate)

1.7400 (estimate)

Soluble (NTP, 1992)

Oral-rat LD50:673 mg/kg; Oral-Mouse LD50: 255 mg/kg

Flammable; decomposes by heating to release toxic nitrogen oxide fumes

Water soluble.

Amides and Imides

Toxic gases are formed by mixing 1-ACETYL-2-PICOLINOYLHYDRAZINE with acids, aldehydes, amides, carbamates, cyanides, inorganic fluorides, halogenated organics, isocyanates, ketones, metals, nitrides, peroxides, phenols, epoxides, acyl halides, and by mixing with strong oxidizing or reducing agents. Flammable gases are formed by mixing with alkali metals.

Safety Information

2811

Warehouse ventilated, low temperature and dry

The flash point of this chemical has not been determined, but it is probably combustible. (NTP, 1992)

Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)

Excerpt from ERG Guide 154 [Substances - Toxic and/or Corrosive (Non-Combustible)]: As an immediate precautionary measure, isolate spill or leak area in all directions for at least 50 meters (150 feet) for liquids and at least 25 meters (75 feet) for solids. SPILL: Increase, in the downwind direction, as necessary, the isolation distance shown above. FIRE: If tank, rail car or tank truck is involved in a fire, ISOLATE for 800 meters (1/2 mile) in all directions; also, consider initial evacuation for 800 meters (1/2 mile) in all directions. (ERG, 2016)

SMALL SPILLS AND LEAKAGE: If you spill this chemical, you should dampen the solid spill material with water, then transfer the dampened material to a suitable container. Use absorbent paper dampened with water to pick up any remaining material. Seal your contaminated clothing and the absorbent paper in a vapor-tight plastic bag for eventual disposal. Wash all contaminated surfaces with a strong soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned. STORAGE PRECAUTIONS: You should keep this material in a tightly-closed container under an inert atmosphere, and store it at refrigerated temperatures. (NTP, 1992)

MINIMUM PROTECTIVE CLOTHING: A laboratory coat and leather shoes should provide you with adequate protection for working with this chemical. RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with a combination filter cartridge, i.e. organic vapor/acid gas/HEPA (specific for organic vapors, HCl, acid gas, SO2 and a high efficiency particulate filter). (NTP, 1992)

Toxicity

highly toxic

Drug Information

ACUTE/CHRONIC HAZARDS: This compound is considered toxic with hazardous decomposition. (NTP, 1992)

EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop. SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment. INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. IMMEDIATELY call a physician and be prepared to transport the victim to a hospital even if no symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing. INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. OTHER: Since this chemical is a known or suspected carcinogen you should contact a physician for advice regarding the possible long term health effects and potential recommendation for medical monitoring. Recommendations from the physician will depend upon the specific compound, its chemical, physical and toxicity properties, the exposure level, length of exposure, and the route of exposure. (NTP, 1992)

azapicyl

Computed Properties

Molecular Weight:179.18
XLogP3:-0.6
Hydrogen Bond Donor Count:2
Hydrogen Bond Acceptor Count:3
Rotatable Bond Count:1
Exact Mass:179.069476538
Monoisotopic Mass:179.069476538
Topological Polar Surface Area:71.1
Heavy Atom Count:13
Complexity:206
Covalently-Bonded Unit Count:1
Compound Is Canonicalized:Yes

Scan the QR Code to Share

Feedback & Suggestions
Send Message

Thank you for your feedback. If you require further assistance, please contact us by email at info@echemi.com or call us at +86-532-55729510.