2-amino-3-methyl-6-methoxybenzothiazolium chloride
-
2-amino-3-methyl-6-methoxybenzothiazolium chloride
structure -
-
CAS No:
322012-65-7
-
Formula:
C9H11ClN2OS
-
Chemical Name:
2-amino-3-methyl-6-methoxybenzothiazolium chloride
-
Synonyms:
3-Methyl-6-methoxy-2-aminobenzothiazolium chloride;DTXSID8025624;CTK4G8372;2-AMINO-3-METHYL-6-METHOXYBENZOTHIAZOLIUM CHLORIDE;6-methoxy-3-methyl-1,3-benzothiazol-3-ium-2-amine;chloride;Benzothiazolium,2-amino-6-methoxy-3-methyl-, chloride (1:1);3-Methyl-6-methoxy-2-amino-benzothiazolium chloride2-amino-6-methoxy-3-methyl-1,3-benzothiazol-3-ium chloride
-
CAS No:
Description
PHYSICAL DESCRIPTION: Fine white clumpy powder. (NTP, 1992)
3-methyl-6-methoxy-2-aminobenzothiazolium chloride is a fine white clumpy powder. (NTP, 1992)
3-methyl-6-methoxy-2-aminobenzothiazolium chloride is a fine white clumpy powder. (NTP, 1992)
Characteristics
67.4
2.62960
3-methyl-6-methoxy-2-aminobenzothiazolium chloride is a fine white clumpy powder. (NTP, 1992)
527° F (decomposes) (NTP, 1992)
1 to 5 mg/mL at 68° F (NTP, 1992)
Slightly soluble in water.
Amines, Phosphines, and Pyridines
3-METHYL-6-METHOXY-2-AMINOBENZOTHIAZOLIUM CHLORIDE is sensitive to exposure to light. This chemical may be incompatible with oxidizing agents. (NTP, 1992)
Safety Information
Flash point data for this compound are not available. It is probably combustible. (NTP, 1992)
Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)
SMALL SPILLS AND LEAKAGE: If you spill this chemical, you should dampen the solid spill material with water, then transfer the dampened material to a suitable container. Use absorbent paper dampened with water to pick up any remaining material. Seal your contaminated clothing and the absorbent paper in a vapor-tight plastic bag for eventual disposal. Wash all contaminated surfaces with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned. STORAGE PRECAUTIONS: You should protect this material from exposure to light. Keep it away from oxidizing materials and store it under refrigerated temperatures. (NTP, 1992)
RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. (NTP, 1992)
Drug Information
EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop. SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment. INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing. INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)
Computed Properties
Molecular Weight:230.72
Hydrogen Bond Donor Count:1
Hydrogen Bond Acceptor Count:4
Rotatable Bond Count:1
Exact Mass:230.0280618
Monoisotopic Mass:230.0280618
Topological Polar Surface Area:67.4
Heavy Atom Count:14
Complexity:191
Covalently-Bonded Unit Count:2
Compound Is Canonicalized:Yes
Learn More Other Chemicals
-
1,3,5-Cycloheptatriene-1-carbonyl chloride (9CI)
103533-75-1
-
3'-De(diMethylaMino)-3'-[[(2-Methoxyethoxy)Methyl]diMethylaMMonio]erythroMycin 9-OxiMe Chloride
151750-47-9
-
decoxymethyl-dimethyl-octyl-azanium chloride
366491-03-4
-
4-[3-(3,5-DICHLORO-PHENYL)-UREIDO]-BENZENESULFONYL CHLORIDE Formula
677326-84-0
-
2,5-DICHLOROBENZYLZINC CHLORIDE Formula
737797-20-5
-
2,5-DIBROMO-3,6-DIFLUOROBENZENESULFONYL CHLORIDE Formula
207853-66-5
-
Dibenzofuran-3-sulfonyl chloride Structure
42138-14-7
-
2,4-Dibromo-5-fluorobenzenesulfonyl chloride Structure
1000578-09-5
-
What is Selenium(I) chloride (99%-Se)
21317-32-8
-
What is 2,6-dibromo-4-methylbenzene-1-sulfonyl chloride
73732-31-7
2-amino-3-methyl-6-methoxybenzothiazolium chloride
SDSRequest for Quotation