6-Methylmercaptopurine riboside
-
6-Methylmercaptopurine riboside
structure -
-
CAS No:
342-69-8
-
Formula:
C11H14N4O4S
-
Chemical Name:
6-Methylmercaptopurine riboside
-
Synonyms:
Inosine,6-S-methyl-6-thio-;9H-Purine,6-(methylthio)-9-β-D-ribofuranosyl-;6-S-Methyl-6-thioinosine;6-Methylmercaptopurine riboside;6-(Methylthio)purine ribonucleoside;6-(Methylthio)-9-β-D-ribofuranosyl-9H-purine;β-D-Ribosyl-6-methylthiopurine;6-(Methylmercapto)purine ribonucleoside;6-Methylthiopurine riboside;6-Methylthioinosine;6-(Methylmercapto)-9-(β-D-ribofuranosyl)purine;6-(Methylthio)-9-β-D-ribofuranosylpurine;Methylthioinosine;SQ 21977;NSC 40774;6-MMPR;NSC 49555;7436-75-1
- Categories:
-
CAS No:
Description
white powder
6-methylmercaptopurine riboside is a white powder. (NTP, 1992)
6-methylmercaptopurine riboside is a white powder. (NTP, 1992)|6-methylthioinosine is a thiopurine that is inosine in which the aromatic hydroxy group is replaced by a methylsulfanediyl group. It is a purine ribonucleoside and a thiopurine.|An analog of inosine with a methylthio group replacing the hydroxyl group in the 6-position.|6-(Methylthio)-9-beta-D-ribofuranosylpurine. An analog of inosine with a methylthio group replacing the hydroxyl group in the 6-position.
6-Methylmercaptopurine riboside Basic Attributes
298.32
298.32
206-442-2
Y5G39SHR0V
DTXSID5030454
29349990
Characteristics
138.82000
0.1
6-methylmercaptopurine riboside is a white powder. (NTP, 1992)
1.85g/cm3
164 °C
636.3ºC at 760mmHg
338.6ºC
1.822
Propylene glycol 6 (mg/mL)
−20°C
(c = 1, H2O) [a]22 D = - 58.0 ± 2
Slightly soluble in water.
Alcohols and Polyols
Safety Information
NONH for all modes of transport
3
22-24/25
UO8985000
Incompatible with strong oxidizing agents.
SMALL SPILLS AND LEAKAGE: If you spill this chemical, you should dampen the solid spill material with water, then transfer the dampened material to a suitable container. Use absorbent paper dampened with water to pick up any remaining material. Seal your contaminated clothing and the absorbent paper in a vapor-tight plastic bag for eventual disposal. Wash all contaminated surfaces with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned. (NTP, 1992)
RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. (NTP, 1992)
Drug Information
EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop. SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment. INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing. INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)
6 Methylmercaptopurine Riboside
Computed Properties
Molecular Weight:298.32
XLogP3:0.1
Hydrogen Bond Donor Count:3
Hydrogen Bond Acceptor Count:8
Rotatable Bond Count:3
Exact Mass:298.07357611
Monoisotopic Mass:298.07357611
Topological Polar Surface Area:139
Heavy Atom Count:20
Complexity:352
Defined Atom Stereocenter Count:4
Covalently-Bonded Unit Count:1
Compound Is Canonicalized:Yes
Learn More Other Chemicals
-
2,6-Dichloropurine riboside
13276-52-3
-
Zeatin riboside
6025-53-2
-
2-Amino-6-chloropurine riboside
2004-07-1
-
Nicotinamide riboside Formula
1341-23-7
-
Nicotinamide riboside chloride Formula
23111-00-4
-
emimycin riboside Formula
34597-52-9
-
Ortho-topolin riboside Structure
50868-58-1
-
2-Aminopurine riboside Structure
4546-54-7
-
What is 6-Methylmercaptopurine
50-66-8
-
What is 6-Chloropurine riboside
5399-87-1