Product
Supplier
Encyclopedia
Inquiry
Home > Encyclopedia > Retene

Retene

Retene structure

Retene 

structure
  • CAS No:

    483-65-8

  • Formula:

    C18H18

  • Chemical Name:

    Retene

  • Synonyms:

    Phenanthrene,1-methyl-7-(1-methylethyl)-;Retene;Phenanthrene,7-isopropyl-1-methyl-;1-Methyl-7-(1-methylethyl)phenanthrene;7-Isopropyl-1-methylphenanthrene;1-Methyl-7-isopropylphenanthrene;NSC 26317;1-Methyl-7-propan-2-ylphenanthrene

  • Categories:

    Biochemical Engineering  >  Plant Extracts

Description

beige flakes


Plates or scales (from ethanol) or pearly-beige small flakes. (NTP, 1992)


Plates or scales (from ethanol) or pearly-beige small flakes. (NTP, 1992)

Retene Basic Attributes

234.34

234.34

207-597-9

0W2D2E1P9Q

26317

DTXSID7058701

Characteristics

0

6.48

Plates or scales (from ethanol) or pearly-beige small flakes. (NTP, 1992)

1.1252 g/cm3 @ Temp: 20 °C

101 °C

390 °C

177.8±13.7 °C

1.642

less than 1 mg/mL at 64° F (NTP, 1992)

5.34E-06mmHg at 25°C

Insoluble in water.

Hydrocarbons, Aromatic

Upon treatment with CrO3 in acetic acid forms retenequinone (C18H1. (NTP, 1992).

Safety Information

3

Stable. Incompatible with strong oxidizing agents.

P273, P391, P501

H410

SMALL SPILLS AND LEAKAGE: If a spill of this chemical occurs, FIRST REMOVE ALL SOURCES OF IGNITION, then you should dampen the solid spill material with acetone and transfer the dampened material to a suitable container. Use absorbent paper dampened with acetone to pick up any remaining material. Seal your contaminated clothing and the absorbent paper in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with acetone followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned. STORAGE PRECAUTIONS: You should store this material in a refrigerator. (NTP, 1992)

RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. (NTP, 1992)

Drug Information

EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop. SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment. INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing. INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)

7-isopropyl-1-methylphenanthrene

Computed Properties

Molecular Weight:234.3
XLogP3:6.5
Rotatable Bond Count:1
Exact Mass:234.140850574
Monoisotopic Mass:234.140850574
Heavy Atom Count:18
Complexity:280
Covalently-Bonded Unit Count:1
Compound Is Canonicalized:Yes

Recommended Suppliers of Retene

  • China CN

    5 YRS

    Business licensed Certified factory
    Manufactory Supplier of Chemical Pesticides,Food Additives,Agrochemicals,Active Pharm Ingredients,Flavors and Fragrances,Chemical Catalyst,Chemical Materials,Chem&Pharm Intermediates,Organic Intermediates,Feed Additive
    CAS No.: 483-65-8
    Grade: Chemical Grade
    Content: 98%
    Inquiry

Scan the QR Code to Share

Feedback & Suggestions
Send Message

Thank you for your feedback. If you require further assistance, please contact us by email at info@echemi.com or call us at +86-532-55729510.