OEM Hot selling Wallpaper Adhesive Powder Wall paper glue powder Wallpaper adhesive

.

Wallpaper with adhesive powder

Wallpaper adhesive

It has a strong paste, is non-toxic, and is made from potatoes until moldy. It is an environmentally friendly product. Can dissolve quickly by stirring in cold water, suitable for various types of wallpapers. Such as regular wallpaper, fiberglass wallpaper, woven wallpaper, heavy wallpaper, and metal wallpaper.

application

1. Dilute enough powder into tap water using the chart below. Stir to achieve smooth consistency. Keep the mixed product about 5 inches. After that, stir it a little more and it's ready.

2. Apply the adhesive to the wallpaper and follow the instructions of the wallpaper. Starting from the top, roll the paper into position and pay attention to rolling out bubbles. Immediately remove excess adhesive and any adhesive on the pattern side with a damp cloth.

3. After the adhesive dissolves, it can be stored in a sealed bucket for 7 days. Stir very well before use, when stored for more than 1 day.

-Color usage

It requires the walls to be clean, dry, not sturdy, without holes, sturdy, and free of dust. First, put the powder into a few percent clean water and stir for half a minute to ensure complete absorption of the powder. After three minutes, stir again. Use a brush to stick the mixed adhesive onto the finished cut wallpaper, fill the surrounding area, fold and emphasize both sides for 5 or 6 minutes, allowing the paste to fully penetrate the back of the paper, and then it can be pasted onto the wall. Firstly, the top of the wallpaper should be extruded with a puller from top to bottom, from the middle to both sides, to create bubbles. Use a wet towel to remove excess paste from the surface wallpaper.

technical data

type

Potato starch

colour

White flakes

density

280-360 kg/m3

PH

8-9

viscosity

15000-20000 MPa. s

Glue: Water

1:25

Application pasting:

Brush and paste on the back of the wallpaper. Be sure to cover the entire back of the paper, including all edges. Let it stand for 5-6 minutes to allow it to be absorbed by paper, then apply the paper to the wall.

Apply paper to the wall:

After pasting onto the wall, start brushing from the top. If it forms a pattern from top to bottom and from the middle to each side, make sure to squeeze out all the bubbles. When applying the next piece of paper to be pasted, make sure it matches the design. Also, it should be noted that each piece of paper should be parallel to the starting edge of the window or wall where you started.

Cleaning:

When this paper is placed on the wall and all the bubbles are processed, any excess paste should be removed with a damp towel.