Introduction
Use:
Binder for coating materials
Relevant identified uses of the substance or mixture and uses advised against
Type of product: Mixture
Mixtures
polyester polyol
ca. 80 % in n-butyl acetate
Information on basic physical and chemical properties
Emergency overview
yellowish, liquid, solvent-like. Flammable liquid and vapour. May cause drowsiness or dizziness
Classification of the substance or mixture
GHS Classification:
Flammable liquids, Category 3 (H226)
Specific target organ toxicity (single exposure), Category 3 (H336) (Narcotic effects)
Mixtures
polyester polyol
ca. 80 % in n-butyl acetate
Hazardous components
n-Butyl acetate
Concentration [wt.-%]: ca. 20
GHS Classification: Flam. Liq. 3 H226 STOT SE 3 H336 (Central nervous system)
Trimethylolpropane
Concentration [wt.-%]: ca. 0.5
GHS Classification: Repr. 2 H361f
Description of first aid measures
General advice: Take off all contaminated clothing immediately.
If inhaled: Take the person into the fresh air and keep him warm, let him rest; if there is difficulty in breathing,
medical advice is required.
In case of skin contact: In case of skin contact wash affected areas thoroughly with soap and plenty of
water. Consult a doctor in the event of a skin reaction.
In case of eye contact: Hold the eyes open and rinse with preferably lukewarm water for a sufficiently long
period of time (at least 10 minutes). Contact an ophthalmologist.
If swallowed: DO NOT induce the patient to vomit, medical advice is required
Precautions for safe handling
Provide sufficient air exchange and/or exhaust in work rooms.
Provided good ventilation and/or local exhaust systems are used, the Workplace Exposure Limit(s) stated in
section 8 should not be exceeded.
Explosion protection required.
The personal protective measures described in section 8 must be observed. The precautions required in the
handling of solvents must be taken. Avoid contact with skin and eyes and the inhalation of vapor.
Keep away from foodstuffs, drinks and tobacco. Wash hands before breaks and at the end of workday. Keep
working clothes separately. Change contaminated or soaked clothing.
Respiratory protection
Respiratory protection required in insufficiently ventilated working areas and during spraying.
Hand protection
Suitable materials for safety gloves; EN 374:
Laminate glove – PE/EVOH/PE; breakthrough time >=480 min.
In the event of contamination, change protective gloves immediately. Recommendation: contaminated gloves
should be disposed of.
Eye protection
Wear eye/face protection.
Skin and body protection
Wear suitable protective clothing.
