(Diethylamino)ethyl acrylate

171.24

171.24

219-378-5

J4T0T1RP9Z

3118

1993

DTXSID4051900

2922199090

29.54000

2.01

1.4425 g/cm³ @ Temp: 20 °C

<-60 °C

70 °C @ Press: 5.0 Torr

165 °F

1.448

The effectiveness of phenolic inhibitors is dependent on the presence of oxygen and the monomers must be stored under air rather than an inert atmosphere. Temp must be kept low to minimize formation of peroxides and other products. ... The acrylic esters may be stored in mild or stainless steel, or aluminum. /Acrylic acid & derivatives/

0.77 psi ( 20 °C)

5.9 (AIR= 1)

DECOMPOSES @ BP; DECOMPOSED BY WATER|React readily with electrophilic, free-radical, and nucleophilic agents /Acrylic acid & esters/

III

6.1(b)

UN 2927 6.1/PG 2

2

22-24-34-43

26-36/37/39-45

AS8225000

T

P280-P302 + P350-P305 + P351 + P338-P310

H302-H310-H314-H317

SRP: At the time of review, criteria for land treatment or burial (sanitary landfill) disposal practices are subject to significant revision. Prior to implementing land disposal of waste residue (including waste sludge), consult with environmental regulatory agencies for guidance on acceptable disposal practices.

Flammable - 2nd degree, Reactive - 2nd degree

|Danger|H302 (97.44%): Harmful if swallowed [Warning Acute toxicity, oral]|P260, P261, P262, P264, P270, P272, P280, P301+P312, P301+P330+P331, P302+P350, P302+P352, P303+P361+P353, P304+P340, P305+P351+P338, P310, P321, P322, P330, P333+P313, P361, P363, P405, and P501|Aggregated GHS information provided by 39 companies from 2 notifications to the ECHA C&L Inventory. Each notification may be associated with multiple companies.

SUITABLE PROTECTIVE CLOTHING & SELF-CONTAINED RESP PROTECTIVE APPARATUS SHOULD BE AVAILABLE FOR USE OF THOSE WHO MAY HAVE TO RESCUE PERSONS OVERCOME BY FUMES. /ACRYLIC ACID & DERIVATIVES/|Protection required for safe handling of acrylic acid and esters commonly includes use of impervious gloves, shoe soles, and clothing; splash-proof goggles ... /Acrylic acid & derivatives/

Awareness of the dangers and of good engineering design are essential to safety. Employees should be instructed about the necessity of cleansing the skin if it is contaminated by materials which are irritants or skin-absorbed. With careful design, however, and complete enclosure of those processes where toxic chemicals or intermediates occur, dangerous exposures can be avoided. /Acrylic acid & derivatives/|SRP: Contaminated protective clothing should be segregated in such a manner so that there is no direct personal contact by personnel who handle, dispose, or clean the clothing. Quality assurance to ascertain the completeness of the cleaning procedures should be implemented before the decontaminated protective clothing is returned for reuse by the workers. Contaminated clothing should not be taken home at end of shift, but should remain at employee's place of work for cleaning.|SRP: The scientific literature for the use of contact lenses in industry is conflicting. The benefit or detrimental effects of wearing contact lenses depend not only upon the substance, but also on factors including the form of the substance, characteristics and duration of the exposure, the uses of other eye protection equipment, and the hygiene of the lenses. However, there may be individual substances whose irritating or corrosive properties are such that the wearing of contact lenses would be harmful to the eye. In those specific cases, contact lenses should not be worn. In any event, the usual eye protection equipment should be worn even when contact lenses are in place.

THE LOWER-MOL-WT ESTERS OF ACRYLIC ACIDS ARE IRRITANTS TO SKIN, EYES & MUCOUS MEMBRANES. /ACRYLIC ACID ESTERS/|A severe skin and eye irritant.

| 2 - Materials that, under emergency conditions, can cause temporary incapacitation or residual injury.| 2 - Materials that must be moderately heated or exposed to relatively high ambient temperatures before ignition can occur. Materials would not under normal conditions form hazardous atmospheres with air, but under high ambient temperatures or under moderate heating could release vapor in sufficient quantities to produce hazardous atmospheres with air.| 1 - Materials that in themselves are normally stable but that can become unstable at elevated temperatures and pressures.

LD50 Rat oral 770 mg/kg|LD50 Rabbit skin 200 mg/kg

Basic treatment: Establish a patent airway. Suction if necessary. Encourage patient to take deep breaths. Watch for signs of respiratory insufficiency and assist ventilations if necessary. Administer oxygen by nonrebreather mask at 10 to 15 L/min. Monitor for pulmonary edema and treat if necessary ... . Monitor for shock and treat if necessary ... . Anticipate seizures and treat if necessary ... . For eye contamination, flush eyes immediately with water. Irrigate each eye continuously with normal saline during transport ... . Do not use emetics. For ingestion, rinse mouth and administer 5 mL/kg up to 200 mL of water for dilution if the patient can swallow, has a strong gag reflex, and does not drool ... . /Irritating materials/|Advanced treatment: Consider orotracheal or nasotracheal intubation for airway control in the patient who is unconscious, has severe pulmonary edema, or is in respiratory arrest. Early intubation at the first sign of upper airway obstruction may be necessary. Positive-pressure ventilation techniques with a bag-valve mask device may be beneficial. Monitor cardiac rhythm and treat arrhythmias if necessary ... . Start an IV with D5W TKO /SRP: "To keep open", minimal flow rate/. Use lactated Ringer's if signs of hypovolemia are present. Watch for signs of fluid overload. Consider drug therapy for pulmonary edema ... . Treat seizures with diazepam (Valium) ... . Use proparacaine hydrochloride to assist eye irrigation ... . /Irritating materials/

THE ACUTE TOXICITY OF THE ACRYLATES DECREASES WITH INCREASING MOLECULAR WEIGHT. ... HUMAN SIGNS & SYMPTOMS FOLLOWING INGESTION OF ACRYLIC MONOMERS INCL COLLAPSE, SEVERE RESPIRATORY DIFFICULTIES, & CNS STIMULATION. ACUTE INHALATION OF HIGHER CONCN MAY CAUSE MARKED IRRITATION, SALIVATION, CONJUNCTIVAL IRRITATION, & PRONOUNCED PULMONARY IRRITATION OR EDEMA. PROLONGED SKIN OR EYE CONTACT MAY RESULT IN SEVERE TISSUE DAMAGE. THE PATHOLOGY FROM SINGLE EXPOSURE IS NONSPECIFIC, CONTRARY TO REPEATED EXPOSURE EFFECTS, WHICH INCL PULMONARY CONGESTION OR HEMORRHAGE & CLOUDY SWELLING OF LIVER & KIDNEY. /ACRYLATES/

... Hydroquinone or monomethyl ether hydroquinone is added to acrylic monomers to stabilize them ... . /Acrylic ester monomers/

2-Propenoic acid, 2-(diethylamino)ethyl ester: ACTIVE

Chemical assay is preferably performed by gas-liquid chromatography or by the conventional methods for determination of unsaturation such as bromination or addition of mercaptan, sodium bisulfide, morpholine, or mercuric acetate. /Acrylic acid & derivatives/|RETENTION TIMES FOR ACRYLATES WERE MEASURED WITH 2 DIFFERENT COLUMNS (C18 CORASIL & C8 LICHROSORB) USING REVERSE-PHASE HIGH PRESSURE LIQ CHROMATOGRAPHY IN ORDER TO OBTAIN THE PARTITION COEFFICIENTS OF ACRYLATES BETWEEN 1-OCTANOL AND WATER (LOG P). /ACRYLATES/

Fire Hazards -> Flammable - 2nd degree, Reactive - 2nd degree