Phenyl phosphate

174.09100

174.09

211-857-7

75M88J863E

DTXSID6044981

Clear, colorless liquid

76.57000

1.15810

Liquid

1.499±0.06 g/cm3(Predicted)

99.5 °C

346.9ºC at 760 mmHg

163.6ºC

In water, 7.41X10+3 mg/L at 25 °C (est)

Keep container tightly closed in a dry and well-ventilated place.

5.66X10-7 mm Hg at 25 °C (est)

Characteristic odor

Henry's Law constant = 8.99X10-13 atm-cu m/mol at 25 °C (est)

pKa = 9.99

Hydroxyl radical reaction rate constant = 3.89X10-12 cu cm/molec-sec at 25 °C (est)

III

UN 3261

34

S26-S36-S37-S39

SZ9652500

Xi

Stable under recommended storage conditions.

P260, P264, P280, P301+P330+P331, P302+P352, P303+P361+P353, P304+P340, P305+P351+P338, P310, P321, P332+P313, P337+P313, P362, P363, P405, P501

H314

SRP: Recycle any unused portion of the material for its approved use or return it to the manufacturer or supplier. Ultimate disposal of the chemical must consider: the material's impact on air quality; potential migration in air, soil or water; effects on animal, aquatic and plant life; and conformance with environmental and public health regulations. If it is possible or reasonable use an alternative chemical product with less inherent propensity for occupational harm/injury/toxicity or environmental contamination.|Product: Offer surplus and non-recyclable solutions to a licensed disposal company. Contact a licensed professional waste disposal service to dispose of this material. Contaminated packaging: Dispose of as unused product.

Incompatible materials: Strong oxidizing agents.

UN 3261

|Danger|H314 (28.57%): Causes severe skin burns and eye damage [Danger Skin corrosion/irritation]|P260, P264, P280, P301+P330+P331, P302+P352, P303+P361+P353, P304+P340, P305+P351+P338, P310, P321, P332+P313, P337+P313, P362, P363, P405, and P501|Aggregated GHS information provided by 61 companies from 3 notifications to the ECHA C&L Inventory. Each notification may be associated with multiple companies.|Warning|H315: Causes skin irritation [Warning Skin corrosion/irritation]|P264, P280, P302+P352, P305+P351+P338, P321, P332+P313, P337+P313, and P362

Eye/face protection: Safety glasses with side-shields conforming to EN166. Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU).|Skin protection: Handle with gloves.|Body Protection: Impervious clothing. The type of protective equipment must be selected according to the concentration and amount of the dangerous substance at the specific workplace.|Respiratory protection: For nuisance exposures use type P95 (US) or type P1 (EU EN 143) particle respirator. For higher level protection use type OV/AG/P99 (US) or type ABEK-P2 (EU EN 143) respirator cartridges. Use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU).

Suitable extinguishing media: Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.|Advice for firefighters: Wear self-contained breathing apparatus for firefighting if necessary.

ACCIDENTAL RELEASE MEASURES: Personal precautions, protective equipment and emergency procedures: Use personal protective equipment. Avoid dust formation. Avoid breathing vapors, mist or gas. Ensure adequate ventilation. Avoid breathing dust. Environmental precautions: Do not let product enter drains. Methods and materials for containment and cleaning up: Pick up and arrange disposal without creating dust. Sweep up and shovel. Keep in suitable, closed containers for disposal.

ACCIDENTAL RELEASE MEASURES: Personal precautions, protective equipment and emergency procedures: Use personal protective equipment. Avoid dust formation. Avoid breathing vapors, mist or gas. Ensure adequate ventilation. Avoid breathing dust. Environmental precautions: Do not let product enter drains.|Precautions for safe handling: Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Further processing of solid materials may result in the formation of combustible dusts. The potential for combustible dust formation should be taken into consideration before additional processing occurs. Provide appropriate exhaust ventilation at places where dust is formed.|Appropriate engineering controls: Handle in accordance with good industrial hygiene and safety practice. Wash hands before breaks and at the end of workday.|Gloves must be inspected prior to use. Use proper glove removal technique (without touching glove's outer surface) to avoid skin contact with this product. Dispose of contaminated gloves after use in accordance with applicable laws and good laboratory practices. Wash and dry hands.|SRP: Local exhaust ventilation should be applied wherever there is an incidence of point source emissions or dispersion of regulated contaminants in the work area. Ventilation control of the contaminant as close to its point of generation is both the most economical and safest method to minimize personnel exposure to airborne contaminants. Ensure that the local ventilation moves the contaminant away from the worker.

IDENTIFICATION AND USE: Phenylphosphate is a clear colorless liquid with a characteristic odor. It is used as a catalyst for resin manufacture and paint manufacture. HUMAN STUDIES: There are no data available. ANIMAL STUDIES: There are no data available.

Phenyl phosphate's production and use as a catalyst for resin and paint manufacturing(1) may result in its release to the environment through various waste streams(SRC).

According to the 2016 TSCA Inventory Update Reporting data, 2 reporting facilities estimate the number of persons reasonably likely to be exposed in the manufacturing, processing, or use of phenylphosphatein the United States may be as low as 10 workers up to 50 workers per plant; the data may be greatly underestimated due to confidential business information (CBI) or unknown values(1).

Phenyl phosphate was reported at a 95 percentile concentration of 4 ug/L in 19 urine samples from males and females ranging in age from 14-85 yrs, residing in Germany(1).

Anaerobic phenol degradation has been shown to proceed via carboxylation of phenol to 4-hydroxybenzoate. However, in vitro the carboxylating enzyme was inactive with phenol; only phenylphosphate (phosphoric acid monophenyl ester) was readily carboxylated. We demonstrate in a denitrifying Pseudomonas strain that phenylphosphate is the first detectable product formed from phenol in whole cells and that subsequent phenylphosphate consumption parallels 4-hydroxybenzoate formation. These kinetics are consistent with phosphorylation being the first step in anaerobic phenol degradation. Various cosubstrates failed so far to act as phosphoryl donor for net phosphorylation of phenol in cell extracts. Yet, cells anaerobically grown with phenol contained an enzyme that catalyzed an isotope exchange between [U-14C]phenol and phenylphosphate. This transphosphorylation activity was anaerobically induced by phenol but was stable under aerobic conditions and required Mn2+ and polyethylene glycol. Activity was optimal at pH 5.5 and half-maximal with 0.6 mM Mn2+, 0.2 mM phenylphosphate, and 1 mM phenol. It is proposed that the phenol exchange/transphosphorylation reaction is catalyzed as partial reaction by an inducible phenol phosphorylating enzyme. The isotope exchange demands that a phosphorylated enzyme was formed in the course of the reaction, which might be similar to the phosphotransferase system of sugar transport.|The anaerobic metabolism of phenol in the beta-proteobacterium Thauera aromatica proceeds via para-carboxylation of phenol (biological Kolbe-Schmitt carboxylation). In the first step, phenol is converted to phenylphosphate which is then carboxylated to 4-hydroxybenzoate in the second step. Phenylphosphate formation is catalyzed by the novel enzyme phenylphosphate synthase, which was studied. Phenylphosphate synthase consists of three proteins whose genes are located adjacent to each other on the phenol operon and were overproduced in Escherichia coli. The promoter region and operon structure of the phenol gene cluster were investigated. Protein 1 (70 kDa) resembles the central part of classical phosphoenolpyruvate synthase which contains a conserved histidine residue. It catalyzes the exchange of free [(14)C]phenol and the phenol moiety of phenylphosphate but not the phosphorylation of phenol. Phosphorylation of phenol requires protein 1, MgATP, and another protein, protein 2 (40 kDa), which resembles the N-terminal part of phosphoenol pyruvate synthase. Proteins 1 and 2 catalyze the following reaction: phenol + MgATP + H(2)O-->phenylphosphate + MgAMP + orthophosphate. The phosphoryl group in phenylphosphate is derived from the beta-phosphate group of ATP. The free energy of ATP hydrolysis obviously favors the trapping of phenol (K(m), 0.04 mM), even at a low ambient substrate concentration. The reaction is stimulated severalfold by another protein, protein 3 (24 kDa), which contains two cystathionine-beta-synthase domains of unknown function but does not show significant overall similarity to known proteins. The molecular and catalytic features of phenylphosphate synthase resemble those of phosphoenolpyruvate synthase, albeit with interesting modifications.

/SRP:/ Immediate first aid: Ensure that adequate decontamination has been carried out. If patient is not breathing, start artificial respiration, preferably with a demand-valve resuscitator, bag-valve-mask device, or pocket mask, as trained. Perform CPR if necessary. Immediately flush contaminated eyes with gently flowing water. Do not induce vomiting. If vomiting occurs, lean patient forward or place on left side (head-down position, if possible) to maintain an open airway and prevent aspiration. Keep patient quiet and maintain normal body temperature. Obtain medical attention. /Organic acids and related compounds/|/SRP:/ Basic treatment: Establish a patent airway (oropharyngeal or nasopharyngeal airway, if needed). Suction if necessary. Watch for signs of respiratory insufficiency and assist respirations if necessary. Administer oxygen by nonrebreather mask at 10 to 15 L/min. Monitor for pulmonary edema and treat if necessary ... . Monitor for shock and treat if necessary ... . For eye contamination, flush eyes immediately with water. Irrigate each eye continuously with 0.9% saline (NS) during transport ... . Do not use emetics. For ingestion, rinse mouth and administer 5 mL/kg up to 200 mL of water for dilution if the patient can swallow, has a strong gag reflex, and does not drool. Activated charcoal is not effective ... . Do not attempt to neutralize, because of exothermic reaction. Cover skin burns with dry, sterile dressings after decontamination ... . /Organic acids and related compounds/|/SRP:/ Advanced treatment: Consider orotracheal or nasotracheal intubation for airway control in the patient who is unconscious, has severe pulmonary edema, or is in severe respiratory distress. Early intubation, at the first sign of upper airway obstruction, may be necessary. Positive-pressure ventilation techniques with a bag-valve-mask device may be beneficial. Consider drug therapy for pulmonary edema ... . Consider administering a beta agonist such as albuterol for severe bronchospasm ... . Monitor cardiac rhythm and treat arrhythmias as necessary ... . Start IV administration of D5W /SRP: "To keep open", minimal flow rate/. Use 0.9% saline (NS) or lactated Ringer's (LR) if signs of hypovolemia are present. For hypotension with signs of hypovolemia, administer fluid cautiously. Consider vasopressors if patient is hypotensive with a normal fluid volume. Watch for signs of fluid overload ... . Use proparacaine hydrochloride to assist eye irrigation ... . /Organic acids and related compounds/

phenylphosphate

Paint and coating manufacturing|Phosphoric acid, monophenyl ester: ACTIVE