Product
Supplier
Encyclopedia
Inquiry
Home > Encyclopedia > Diethyl N,N-dibutylphosphoramidate

Diethyl N,N-dibutylphosphoramidate

Diethyl N,N-dibutylphosphoramidate structure

Diethyl N,N-dibutylphosphoramidate 

structure
  • CAS No:

    67828-17-5

  • Formula:

    C12H28NO3P

  • Chemical Name:

    Diethyl N,N-dibutylphosphoramidate

  • Synonyms:

    Phosphoramidic acid,N,N-dibutyl-,diethyl ester;Phosphoramidic acid,dibutyl-,diethyl ester;Diethyl N,N-dibutylphosphoramidate

Description

Diethyl dibutylphosphoramidate is a brown liquid. (NTP, 1992)


Diethyl dibutylphosphoramidate is a brown liquid. (NTP, 1992)

Diethyl N,N-dibutylphosphoramidate Basic Attributes

265.33 g/mol

265.33

267-239-2

2811

DTXSID8025042

Characteristics

38.8 Ų

1.015 at 68.2 °F (NTP, 1992)

115 °C @ Press: 3 Torr

greater than 212 °F (NTP, 1992)

less than 1 mg/mL at 68° F (NTP, 1992)

Insoluble in water.

Amines, Phosphines, and Pyridines

Organophosphates, such as DIETHYL DIBUTYLPHOSPHORAMIDATE, are susceptible to formation of highly toxic and flammable phosphine gas in the presence of strong reducing agents such as hydrides. Partial oxidation by oxidizing agents may result in the release of toxic phosphorus oxides.

Safety Information

This chemical is probably combustible. (NTP, 1992)

Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)

Excerpt from ERG Guide 154 [Substances - Toxic and/or Corrosive (Non-Combustible)]: As an immediate precautionary measure, isolate spill or leak area in all directions for at least 50 meters (150 feet) for liquids and at least 25 meters (75 feet) for solids. SPILL: Increase, in the downwind direction, as necessary, the isolation distance shown above. FIRE: If tank, rail car or tank truck is involved in a fire, ISOLATE for 800 meters (1/2 mile) in all directions; also, consider initial evacuation for 800 meters (1/2 mile) in all directions. (ERG, 2016)

SMALL SPILLS AND LEAKAGE: If you spill this chemical, FIRST REMOVE ALL SOURCES OF IGNITION. Then, use absorbent paper to pick up all liquid spill material. Your contaminated clothing and absorbent paper should be sealed in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with 60-70% ethanol followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned. STORAGE PRECAUTIONS: You should store this material under ambient temperatures. (NTP, 1992)

MINIMUM PROTECTIVE CLOTHING: If Tyvek protective clothing is not worn during the handling of this chemical, wear disposable Tyvek sleeves taped to your gloves. RECOMMENDED RESPIRATOR: Where the neat test chemical is stored, weighed and diluted, wear an approved half face respirator equipped with a combination filter cartridge, i.e. organic vapor/acid gas/HEPA, (specific for organic vapors, HCl, acid gas SO2 and a high efficiency particulate filter). (NTP, 1992)

Drug Information

Excerpt from ERG Guide 154 [Substances - Toxic and/or Corrosive (Non-Combustible)]: TOXIC; inhalation, ingestion or skin contact with material may cause severe injury or death. Contact with molten substance may cause severe burns to skin and eyes. Avoid any skin contact. Effects of contact or inhalation may be delayed. Fire may produce irritating, corrosive and/or toxic gases. Runoff from fire control or dilution water may be corrosive and/or toxic and cause pollution. (ERG, 2016)

EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop. SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. IMMEDIATELY call a hospital or poison control center even if no symptoms (such as redness or irritation) develop. IMMEDIATELY transport the victim to a hospital for treatment after washing the affected areas. INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. IMMEDIATELY call a physician and be prepared to transport the victim to a hospital even if no symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing. INGESTION: CHOLINESTERASE INHIBITORS ARE EXTREMELY TOXIC AND FAST-ACTING POISONS. Atropine is an antidote for cholinesterase inhibitors but should only be administered by properly trained personnel. In the absence of this option and if the victim is conscious and not convulsing, it may be worth considering the risk of inducing vomiting, even though the induction of vomiting is not usually recommended outside of a physician's care. Ipecac syrup or salt water may be used to induce vomiting in such an emergency. IMMEDIATELY call a hospital or poison control center and transport the victim to a hospital. If the victim is convulsing or unconscious, do not give anything by mouth, assure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)

Diethyl N,N-dibutylphosphoramidate Use and Manufacturing

Phosphoramidic acid, N,N-dibutyl-, diethyl ester: INACTIVE

Computed Properties

Molecular Weight:265.33
XLogP3:2.9
Hydrogen Bond Acceptor Count:4
Rotatable Bond Count:11
Exact Mass:265.18068075
Monoisotopic Mass:265.18068075
Topological Polar Surface Area:38.8
Heavy Atom Count:17
Complexity:206
Covalently-Bonded Unit Count:1
Compound Is Canonicalized:Yes

Scan the QR Code to Share

Feedback & Suggestions
Send Message

Thank you for your feedback. If you require further assistance, please contact us by email at info@echemi.com or call us at +86-532-55729510.