Elastic waterproof paint

Product composition:

Elastic waterproof coating is made from imported elastic acrylic copolymer emulsion, facial filler and various additives.

Product features:

The elastic waterproof coating has excellent elasticity and adhesive force, the water resistance of the putty layer is excellent, the weatherability is excellent, and the protection of leakage and mildew, the construction is simple, non-toxic and safe.

Product use:

Elastic waterproof coating can be used for cracks in the interior and exterior walls and ceilings of concrete, gypsum board and cement, as well as interface connections.

Instructions:

Surface treatment: the quality of cement mortar and concrete base shall conform to jgj73-91 "construction decoration project acceptance specification". The base surface must be clean, dry, solid, oil free and other dirt, with a PH of less than 10. When the metope of old film coating, should be loose, shed, powdery film is clear clean, and sanded flat with sandpaper. In case of mold wall, wash with 25% bleach hot water, let the cleaning solution remain on the surface for 10 minutes, then rinse thoroughly with water and then finish the coating after 48 hours. The surface of the surface and cracks applied in the construction paint special putty. After processing the metope, need to be in metope after drying the construction as soon as possible, lest recontaminate.

Construction method: it is usually required 2~3 times to block the crack.

Thinner: no thinner.

Back road: use the high - level building emulsion paint special sealing primer.

Tool cleaning: water.

Coating intervals: 23 + 2 ℃, the minimum 24 hours.

Technical indicators:

Theoretical coating rate: depending on the fracture condition

Specific gravity: 1.22

Flash: no

Elongation: > 200%

Drying time: 5 hours (23 + 2 ℃)

Storage period: 6 months

Storage method:

Storage: must be stored in accordance with state regulations. The storage environment should be dry, cool, well ventilated, avoid high temperature and stay away from fire source. The packing container must be sealed.

Notes:

1. Putty special polymer should be stored in a cool, dry, from the sun's warehouse, storage temperature 0 ~ 40 ℃.

2. Be especially careful about the newly completed buildings, because the walls may be too alkaline. The early construction may cause blistering, the coating will be white and even fall off.

3. The surface is loose and the metope that depowders seriously, unfavorable construction.

4. When construction, such as the base material is too dry, should be sprayed (or brush) water or advanced building latex paint special sealing primer treatment.

5. The temperature is below 10 ℃, relative humidity is more than 85%, unfavorable construction.

6. It is forbidden to mix oil or organic solvents during the use of putty.

7. Transportation can be handled according to non-hazardous materials.