Product
Supplier
Encyclopedia
Inquiry
Home > Encyclopedia > Phenol, 4-(1,1-dimethylpropyl)-, potassium salt

Phenol, 4-(1,1-dimethylpropyl)-, potassium salt

Phenol, 4-(1,1-dimethylpropyl)-, potassium salt structure

Phenol, 4-(1,1-dimethylpropyl)-, potassium salt 

structure
  • CAS No:

    53404-18-5

  • Formula:

    C11H16O.K

  • Chemical Name:

    Phenol, 4-(1,1-dimethylpropyl)-, potassium salt

  • Synonyms:

    Phenol,4-(1,1-dimethylpropyl)-,potassium salt (1:1);Phenol,4-(1,1-dimethylpropyl)-,potassium salt;p-tert-Amylphenol potassium salt

Phenol, 4-(1,1-dimethylpropyl)-, potassium salt Basic Attributes

202.33400

202.07599658

258-524-2

P5T3603I6N

DTXSID9035757

Characteristics

23.06000

3.51800

solid

1.145g/cm3

262.5ºC at 760 mmHg

122.4ºC

No rapid reaction with air. No rapid reaction with water.

Phenolic Salts

Reacts as a basic organic salt.

Safety Information

Flash point data for this chemical are not available. It is probably combustible. (NTP, 1992)

Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)

STORAGE PRECAUTIONS: You should store this material in a refrigerator. (NTP, 1992)

MINIMUM PROTECTIVE CLOTHING: If Tyvek-type disposable protective clothing is not worn during handling of this chemical, wear disposable Tyvek-type sleeves taped to your gloves. RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. (NTP, 1992)

Drug Information

EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop. SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. IMMEDIATELY call a hospital or poison control center even if no symptoms (such as redness or irritation) develop. IMMEDIATELY transport the victim to a hospital for treatment after washing the affected areas. INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing. INGESTION: DO NOT INDUCE VOMITING. Phenols are very toxic poisons AND corrosive and irritating, so that inducing vomiting may make medical problems worse. IMMEDIATELY call a hospital or poison control center and locate activated charcoal, egg whites, or milk in case the medical advisor recommends administering one of them. If advice from a physician is not readily available and the victim is conscious and not convulsing, give the victim a glass of activated charcoal slurry in water or, if this is not available, a glass of milk, or beaten egg whites and IMMEDIATELY transport victim to a hospital. If the victim is convulsing or unconscious, do not give anything by mouth, assure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)

Phenol, 4-(1,1-dimethylpropyl)-, potassium salt Use and Manufacturing

Phenol, 4-(1,1-dimethylpropyl)-, potassium salt (1:1): ACTIVE

Computed Properties

Molecular Weight:202.33
Hydrogen Bond Acceptor Count:1
Rotatable Bond Count:2
Exact Mass:202.07599658
Monoisotopic Mass:202.07599658
Topological Polar Surface Area:23.1
Heavy Atom Count:13
Complexity:137
Covalently-Bonded Unit Count:2
Compound Is Canonicalized:Yes

Scan the QR Code to Share

Feedback & Suggestions
Send Message

Thank you for your feedback. If you require further assistance, please contact us by email at info@echemi.com or call us at +86-532-55729510.