Product
Supplier
Encyclopedia
Inquiry
Home > Encyclopedia > 2-Nitro-1-butanol

2-Nitro-1-butanol

2-Nitro-1-butanol structure

2-Nitro-1-butanol 

structure

Description

colourless liquid


2-nitro-1-butanol is a colorless clear amber liquid. pH (0.1 molar solution) 4.51. (NTP, 1992)


2-nitro-1-butanol is a colorless clear amber liquid. pH (0.1 molar solution) 4.51. (NTP, 1992)

2-Nitro-1-butanol Basic Attributes

119.11900

119.12

210-188-8

3635

DTXSID9025748

2905590090

Characteristics

66.05000

0.55720

2-nitro-1-butanol is a colorless clear amber liquid. pH (0.1 molar solution) 4.51. (NTP, 1992)

1.3332 g/cm3 @ Temp: 25 °C

-47 °C

105 °C

97.7ºC

1.446

10 to 50 mg/mL at 64° F (NTP, 1992)

10 mm Hg at 221° F (NTP, 1992)

Soluble in water.

Alcohols and Polyols

Flammable and/or toxic gases are generated by the combination of alcohols with alkali metals, nitrides, and strong reducing agents. They react with oxoacids and carboxylic acids to form esters plus water. Oxidizing agents convert them to aldehydes or ketones. Alcohols exhibit both weak acid and weak base behavior. They may initiate the polymerization of isocyanates and epoxides.

Safety Information

Stable. Combustible.

This chemical is probably combustible. (NTP, 1992)

Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)

SMALL SPILLS AND LEAKAGE: If you should spill this chemical, use absorbent paper to pick up all liquid spill material. Seal the absorbent paper, as well as any of your clothing which may be contaminated, in a vapor-tight plastic bag for eventual disposal. Wash any surfaces you may have contaminated with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned. STORAGE PRECAUTIONS: You should store this material under ambient temperatures. (NTP, 1992)

RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. (NTP, 1992)

Drug Information

EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop. SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment. INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing. INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)

2-Nitro-1-butanol Use and Manufacturing

Uses

Organic synthesis.

1-Butanol, 2-nitro-: INACTIVE

Computed Properties

Molecular Weight:119.12
XLogP3:0.3
Hydrogen Bond Donor Count:1
Hydrogen Bond Acceptor Count:3
Rotatable Bond Count:2
Exact Mass:119.058243149
Monoisotopic Mass:119.058243149
Topological Polar Surface Area:66
Heavy Atom Count:8
Complexity:77.8
Undefined Atom Stereocenter Count:1
Covalently-Bonded Unit Count:1
Compound Is Canonicalized:Yes

Scan the QR Code to Share

Feedback & Suggestions
Send Message

Thank you for your feedback. If you require further assistance, please contact us by email at info@echemi.com or call us at +86-532-55729510.